Studio-technologies 50 2000 Bedienungsanleitung PDF herunterladen (Seite 20)

Issue 4, July 2000 Model 50/51 User Guide

Page 20 Studio Technologies, Inc.

Configuration

Many StudioComm functions can be

configured to meet the exact needs of

your installation. Heres an overview of

what you can configure:

• 10dBV or +4dBu level for each input

• Stereo or mono for each input

• 10dBV or +4dBu level for the dub

output

• Dim level

• Auto dim off function

• Studio source follows control room or

headphone source

• Headphone source is independently

selected or follows control room

source

• Momentary or latching operation for

mono, talk to studio, talk to phones,

and slate buttons

• Talk to phones interrupts or adds to

phones source

• Slate feed to phones

• 50Hz slate tone on or off

• Dub source is independently selected

or follows control room source

• Remote control room source select

parameters

The Configure button allows the Model 51

to go into the configure mode. While in the

configure mode, all the Model 51s buttons

and LEDs are associated with configure

functions. Refer to the Model 51 Configu-

ration Chart later in this section.

To enter the configure mode, press and

hold the Configure button for two sec-

onds. While in the configure mode, all

audio outputs switch off and the orange

LED beside the Configure button will flash.

As you make changes, the Model 51

keeps track of the new settings and up-

dates the system when you exit the config-

ure mode. You must exit the configure

mode before any changes take effect.

Input Sensitivity

The CR/Studio column of seven red LEDs

shows you whether an input is set to be

compatible with 10dBV or +4dBu signal

levels. When a red LED in the CR/Studio

column is off, it means the input is set to

10dBV. When lit, the corresponding input

is set to +4dBu. Just press the CR/Studio

buttons to toggle inputs 1 through 7

between 10dBV and +4dBu.

For convenience, Input 7 is located on the

front panel of the Model 50. It has a green

LED beside it labeled +4 Input Level.

When lit, it tells you that Input 7 is set for

+4dBu. This means each time you con-

nect a new signal to Input 7, you dont

have to go into the configure mode to

determine the input sensitivity. You should

note, however, that configure settings

arent updated until you leave the config-

ure mode, so the +4 Input Level LED

wont reflect a change until you exit.

Stereo/Mono Input

The Phones/Studio column of seven green

LEDs indicates whether an input is config-

ured for mono or stereo operation. When

an LED in this column is off, the input is

set for stereo; the LED on means the

corresponding input is set for mono. In

mono mode, the left input is sent out both

the left and right outputs. To toggle a

channel between stereo and mono, press

and hold the Phones/Studio button and

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 52 53

Kommentare zu diesen Handbüchern

Keine Kommentare